You’ll soon come to learn that I am kind of a wreath fanatic. I am not exactly sure when this happened, but I love them. This tutorial provides you detailed instructions for how to make your very own holiday wreath. Embellish as you see fit for your own home.

Ribbon

Select whatever you like. I prefer wire edged because it’s bendy and will stay put.

Fastener

Floral wire is the legit way to do this, but I didn’t have any and I am impatient so I used twist ties I had in the kitchen.

Wreath

This one happens to be real, but it doesn’t have to be.

Step 1

Darn, I forgot to tell you that you need scissors…go grab a pair - I will wait. Now, cut a piece of ribbon a few inches long. Bend it in half and secure a twist tie tightly around it once or twice.

Step 2

Select a location that you like on the wreath and secure the remaining end of the twist tie around the branch. Try to place it far enough in that you do not see the fastener.

Step 3

Pouf out {very technical terminology} the ribbon with your fingers. {Repeat steps 1-3 for as many pieces as you would like on your wreath}

Step 4

Bottom of Bow: Cut a piece of ribbon twice as long as you would like the tails of the bow to be. Example: For 3 “ tails cut the ribbon at 6”. {Truth, I did not do this, I just cut a longer piece} Next, fold the ribbon end to end with the open end facing up.

Step 5

Create Cute Edge: Fold the ribbon in half long ways

Step 6

Cut from an inch or two down the folded edge on a diagonal up to the corner of the open edges

Step 7

Open it up…voila! Nicely done.

Step 8

Secure tails of bow the same way you did with everything else you have attached previously

Step 9

Make hills and valleys with your ribbon making sure to hold onto the bottom of each valley as you create how you want your bow to look. I decided I just wanted a simple, traditional bow. Since you have already secured the bottom of the bow to the wreath you do not need to allow any extra ribbon to hang down. Simply cut at the bottom of the last valley and secure with twist tie. {you may need a larger one for this because it gets thick. Also, be sure to twist it tightly}

Step 10

Fasten the top of the ribbon a little bit over the tails so that it looks like one piece.

Step 11

Admire your work. Great job. Go hang it up! If there is not already a loop in the back for hanging you can use an over door hook specifically designed for holding wreaths or add a small piece of ribbon or rope around the top.